The Tyke Supply HS-33 is a Hand Truck / Dolly made from commercial grade aluminum Buy directly: http://www.tykesupply.com/Hand_Trucks... Shop on Amazon: http://amzn.to/2mOQy3D Want to make your own videos like this? Check out Explaindio software at: http://independentflorida.com/explaindio ______________________________________________________ Transcript: Hi everyone! We're back and today we are going to look at the assembly instuctions for the Tyke Supply HS-33. This model is a stair climbing hand truck made from commercial grade aluminum. The assembly instructions left some details out, so we want to take a minute to cover the full instructions for you to make it as easy as possible. This is how it arrives. It is a pretty reasonable size box, and it is packaged well with shipping straps. The main components are just inside the box and then you will find the wheel assembly, large sleeves, long handle and mounting brackets in the smaller, inner box. You will only need a few tools for the assembly process. You can also use sockets instead of wrenches if you prefer. I used wrenches and it was pretty simple. Here are the installation instructions. There are a few parts that are not real clear on these, and we will touch on each of those parts in this video. So here is step #1 In this step, we will attach the nose of the dolly to the frame and the brackets for the axle. The instructions don't show the brackets up close, so here is the easiest way to make sure they are attached properly. The ridge on this piece goes inside the channel of the frame. Then as you see this angled piece, it angles back towards the center of the hand truck. Once this piece is attached, the next bracket piece is pretty straightforward. Just line the ridge and the channel up. This hole at the back is the one that will be used for the axle in the next step. Now for step 2. Here we will be installing the axle. It just slides through the hole we saw in the last step. Now take these spring pins and insert them in the holes predrilled in the axle. You will need the hammer for this. Don't be afraid to hit them, it will take some pressure to get them to seat into the axle properly. Moving onto step 3. This is the step that is the least clear on the actual instructions. This picture shows the order that you should be installing the parts. The small sleeve, followed by a washer. Then the large sleeve and then slide the wheel assembly over the large sleeve. This is the part the instructions omitted. It doesn't mention the large sleeve at all. Here you can see the sleeve up close. I found it easiest to put the sleeve on the axle and then slide the wheels over vs putting the sleeve inside first. Now with the wheels on, you will put another washer and the cotter pin to secure the wheel assembly. Now the final step is installing the handle on step 4. This is very straightforward, just pay attention to the order of the parts. From outside in, you will have the frame, the normal handle, the long handle, then the short loop. It may take some pressure to the get the long handle and short loop to nestle in properly. Secure the screws and there you have it. This is fully assembled HS-33 from Tyke Supply. Very simple, just remember how to attach the first bracket and the wheel assembly goes over the long sleeve. Leave any questions or comments below. We will also have a full review of this product coming soon.
Tyke Supply HS33 Assembly Video Hand Truck / Dolly - YouTube |
| 42 Likes | 42 Dislikes |
| 12,001 views views | 27 followers |
| How-to & Style | Upload TimePublished on 16 Mar 2017 |
Không có nhận xét nào:
Đăng nhận xét